Someone suggested simplif圓d may give more control, to make this work I think the internal supports need to bond properly, their gcode ones do, and no idea how to do it. Well i had to try, 10hr print still running when I got up this morning, won't be doing that again. Some exterior blobbing that scrapes off, some edges (aileron recesses) very weak. Also no support in one section of wing (designed like that), may be worse because it didn't print the horizontal section. I tried the gcode files supplied but very stringy and some errors, expected as for a direct drive print head and mine is bowden so retract will be off. At 0.15 in Cura it says 6 hrs which would be about 7ish then, but at least it would work ok ? I think you are right on the layer height, I know it takes longer but that is what the pub and a good night's sleep is for. Thanks Drayson, don't waste too much time or plastic on it though
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |